Restaurant Equipment Replacement Parts

This replacement bearing bolt is located in the swivel mechanism of the VCM 44. The swivel lock arm attaches to the face of this part. Over time th...

New replacement plastic knob for the VCM 25 and 40. This knob installs on four different locations on the VCM 25 and 40: Switch Handle  Tilt Handl...

New two-piece spin off disk for the VCM 40 and 44. Protect your motor and upper bearing from water damage. This part will take the water that falls...

Replacement Sheeter Blades Set for the ANETS SDR-42, Two Pass Dough Roller  These blades are used to remove dough from the rollers. Direct replace...

Introducing the JPM QUAD CHOPPER!  With our Quad Chopper assembly you'll be ready to slice and chop with a FOUR BLADE SETUP! This JPM Parts exclus...

New outer press plate for the Xebeco XeSRD20 dough dividers. Each divider uses 16 outer press plates and 4 inner plates.

It's becoming more common for the Stephan VCM 44 lids to crack on the square hinge tab. We designed a replacement tab that is made directly to the ...

New cellular rubber door gasket for the Stephan VCM 44 models. Also known as the "Seal Profile." Our gaskets are a direct OEM replacement and molde...

Designed to remove the (often stuck) nut on the bottom of the knife blade assembly. Precision laser cut from 304 stainless steel for long tern dura...

New set of wheels for the Hobart/Stephan VCM 40 and 25. Made from strong, white acetal plastic. Replacement for the following OEM Part Numbers:...

Stainless steel wrench set for removing and tightening the HCM 300/450 cutting assembly. Designed and manufactured by JPM. JPM Original Product

This is one of three parts needed for the complete old style bowl seal. This sits underneath the metal plate located on bottom of the bowl in the o...

This is a brand new, complete knife cutter assembly for the Stephan VCM 44. Every component in this assembly is 100% stainless steel.' Our cutting ...

Our new blades for the Hobart HCM 450 are manufactured by JPM in California. Our blades feature: 400 Series Stainless Steel Precision Heat Treatme...

New engagement hook for the Xebeco XeSRD20 dough dividers.

Direct replacement pin for the VCM 25 and 40 lid locking handle. CNC machined from stainless steel material. Replacement for the following OEM P...

This aluminum wrench is used to tighten and loosen the bowl seal at the bottom of the mixer. It is highly recommended to use this wrench when insta...

Replace pack of o-rings for the stainless and aluminum style lid bolts. Replacement for the following OEM Part Numbers: - Stephan VCM 44:...

New locking handle plate for the VCM 25 and 40. Replacement for the following OEM Part Numbers: - Hobart VCM 40: M-82859- Stephan VCM 40: ...

This replacement polyurethane buffer is designed for the VCM 44 tilting post. Its polyurethane composition offers enhanced resistance to oils and g...

New inner press plate for the Xebeco XeSRD20 dough dividers. Each divider uses 16 outer press plates and 4 inner plates.

New plastic lid insert replacement for the VCM 44. If the plastic lid bushing is worn out or missing it will cause the baffle arm to hit the inside...

Replacement lid bolt for the stainless steel lids only. In acidic environments this bolt can become corroded and cause issues with the lid opening ...